Garland M60XR, Installation And Operation Manual

Page: 10 / 32

Part # 4515576 Rev 1 (01/21/10) Page 10
CAUTION: Should burner ignition fail within 5 seconds,
turn the burner valve off and repeat steps 1 through 5. If
ignition continues to fail, consult your factory authorized
service agency.
Ovens
Standard Ovens
Lighting:
1. Push in the main / pilot gas valve and turn it counter-
clockwise to the IGNITION position.
2. Lower the front kick panel.
3. Holding the oven gas valve fully in, press the red piezo
igniter button several times.
4. When the pilot burner is lit, continue holding in the oven
gas valve for 20 seconds, then release it. If the pilot goes
out, wait five minutes and try again.
5. When the pilot flame is established, push the gas
valve in again and turn it counter-clockwise to the full
ON position, then set the thermostat to the desired
temperature.
Shut-Down:
1. Turn all valves to the OFF position and the safety device
will disengage within 60 seconds.
2. If the unit is to be shut down for an extended time, close
the in-line gas valve.
Re-lighting:
1. Turn all gas valves off.
2. Wait five minutes.
3 Follow procedure under “Lighting” at left.
OPERATION Continued
Convection Ovens (RC)
Lighting:
Same as standard oven.
Start-Up:
1. Activate the power switch to COOK position.
2. Turn oven valve ON.
3. Turn thermostat to desired setting.
Cool Down:
1. Turn thermostat and oven valve OFF.
2. Open door.
3. Activate power to the COOL DOWN position.
The motor on your range convection oven is maintenance
free since it is constructed with self-lubricating sealed ball
bearings. It is designed to provide durable service when
treated with ordinary care. We have a few suggestions to
follow on the care of your motor.
A When the motor is operating, it cools itself internally by
air entering the rear of the motor case, provided proper
clearance has been allowed.
B. Since the blower wheel is in the oven cavity it is at the
same temperature as the oven. If the motor is stopped
while the oven is hot, the heat from the blower wheel is
conducted down the shaft and into the armature of the
motor. This action could shorten the motor life.
C. We recommend, at the end of the bake or roasting
period, when the oven will be idle for any period of time
or before shutting down completely, that the doors be
left open, and by use of the cool down position on the fan
switch, the fan continues to run for at least 20 minutes.
Note: The convection oven motor should never be turned
“OFF” during cooking or when the oven is “HOT”.