Garland M series, Operation Manual

Page: 7 / 48

Part # 1382680 Rev 3 (05/10/11) Page 7
INSTALLATION Continued
Installation Instructions for
High Profile Backguards and Shelves
1. Remove front panel, (5), by lifting upward.
2. With back panel, (4), still attached to the uprights, (2 &3),
drop the uprights into the rectangular openings at the
rear of the range, (1).
3. Fasten the uprights, (2 & 3), to the range with four, (4),
5/16” x 18 and flat washers, (6 & 7).
4. If the range is in a battery line-up, fasten units together at
hole marked “X” with 1/4” x 20 bolts, nuts and washers.
5. Reattach the front panel, (5) to the backguard with sheet
metal screws previously removed.
1
"X"
"X"
2
5
8
4
3
6
7
Installation Instructions for
Salamander or Cheesmelter
1. Remove front panel, (5), by removing two, (2), sheet
metal screws from the underside of the salamander or
cheesemelter.
2. With back panel, (4), still attached to the uprights, (2 & 3),
drop the uprights into the rectangular openings at the
rear of the range, (1).
3. Fasten the uprights, (2 & 3), to the range with four, (4),
5/16” x 18 and flat washers, (6 & 7).
4. If the range is in a battery line-up, fasten units together at
hole marked “X” with 1/4” x 20 bolts, nuts and washers.
5. Reattach the front panel, (5) to the salamander or
cheesemelter with sheet metal screws previously
removed.
~
1
"X"
"X"
2
8
4
3
6
7
5
Garland
Assembly of Battery
All heavy duty batteried equipment is aligned and fitted at
the factory, from left to right and must be installed in this
order. There is a diagram provided with every heavy duty
battery.
All models described, except model M110XMmay be
installed to battery with GARLAND M/MS/MST40 Series
Ranges, sharing common manifold connections.
A. All such units should be placed in their respective battery
position. Detach valve panels to prevent damage,
remove them from the area where the battery is being
assembled.