![background image](http://html1.mh-extra.com/html/garland/best-710-dpg-5-in-1/best-710-dpg-5-in-1_instruction-manual_3653582054.webp)
English
54/174
3. Squeeze the primer (F) several times (7-10 times)
until the fuel reaches the carburetor.
4. Pull the starter rope until you hear an engine
explosion or the engine starts.
5. Move the air lever (E) to the position (normal
working position).
6. If the engine only made an explosion and did not
start, pull the starter rope again until the engine starts.
Let the engine warm up for a minute before starting
work with the machine.
6.4.3. STARTING THE MACHINE FROM HOT
1. Move the switch (A) to the “I” position.
2. Move the lever (E) to the position.
3. Pull the start rope until the machine starts.
If the machine does not start after pulling at the rope
a few times, please refer to the cold start up section.
6.4.4. ENGINE STOPPAGE
1. Let go of the accelerator (C) and let the engine run
at idle speed for a few seconds.
2. Stop the engine by displacing the switch from the
(A) position to the ¨O¨ position (stoppage).
6.4.5. POINTS TO BE VERIFIED AFTER MACHINE
STARTS
It is neccesary to pay attention to posible loosening
or overheating of parts of the machine. If you detect
any anomalies stop inmediatly the machine and check
it carefully. In case of failure take the machine to
the repair service. In any case you should continue
working if you feel that the performance is not correct.
Do not use the machine if it is damaged or
incorrectly regulated.
6.4.5.1. CHECKING THE CLUTCH
After starting up and the engine is hot, the cutting
tool must not be moved if the engine is idle. If the
cutting tool turns with the engine running and without
accelerating, it will be necessary to regulate the idling
regime of the engine. To do this, turn the carburetor
nut “T” until the engine stops.
If you are unable to regulate the idling regime to stop
the cutting tool, because the engine stalls, please
contact the customer service for help.
The regulation of the screws (H) and (L) must only be
carried out by an official technical servicer.
6.4.5.2. CHAIN AUTOMATIC LUBRICATION CHECK
After starting the engine, accelerate the machine until
the chain rotates at a medium speed and check if the
machine greases the chain, for this it will be worth
Summary of Contents for BEST 710 DPG-5 IN 1
Page 170: ...Portugu s 170 174 NOTES...
Page 172: ......