Hoopmaster LT Portable Backstop
-12-
Operation
1.
Before operating the unit, read all caution, warning, and information labels.
2.
To raise the unit from the stored position.
a.
Make sure the unit is in the correct position on the court
and drop locator pins to engage bushings in the floor.
b.
Attach rear anchor bar to the floor anchors.
c.
Step on the setting pad levers to engage the latches.
d.
Remove the safety pin from the slide bar. Loosen the
locking knob.
e.
Using the handle on the top of the rear upright, lift the
upright and rotate to the full up position.
f.
Install the safety pin into the slide tube locking bar and
tighten locking knob.
3.
To lower the unit from the playing position.
a.
Loosen the locking knob and remove the safety
pin from the slide tube locking bar.
b.
Using the handle on the top of the rear upright,
pull the upright back and slowly rotate it to the full
down position.
c.
Install the safety pin into the slide tube locking
bar. Tighten the locking knob.
4.
If the unit is to be moved to storage:
a.
Remove the rear anchor bar
b.
Retract the locating pins.
c.
Raise the setting pads until the unit is fully on all four
casters.
d.
If board is to be removed,
the shipping brackets must
be installed first.
5.
Roll the unit to the storage facility.
Summary of Contents for Hoopmaster LT
Page 3: ...Hoopmaster LT Portable Backstop 2 Specification Model 9305...
Page 15: ......