Hoopmaster LT Portable Backstop
7)
To level the backboard in the horizontal plane, loosen the two goal carriage bolts
and the two 3/8 bolts at the bottom of the board mounting bracket that attach the
bracket to the backboard. Level the board and tighten all four bolts securely.
NOTE:
Do not remove the goal bolts or the 3/8” board mounting bolts. It is only necessary to
loosen these bolts. Once the board has been leveled, make sure these bolts are securely
tightened.
8) To level the backboard in the vertical plane, loosen the two bolts at the rear yoke
brace mount on top of the boom. Refer to Figure 7. Using a wrench, adjust the
leveling bolt in the board-mounting bracket until the backboard is plumb. Tighten the
locking nuts on the leveling bolt. Tighten the two bolts at the rear yoke brace mount
securely.
Figure 7
8)
Attach plumb bobs to the front corners of the backboard. Plumb bobs should
hang down from the corners to where they are almost touching the floor.
10)
Check plumb bobs with marks that were located in step 5. If the plumb bobs do
not line up exactly with the marks on the floor, adjust the location of the unit
accordingly.
- 8 -
