GT-200 Instructions
Thank you for choosing the GT-200 System.
The GT-200 system is an effective, and clean method of flying insect control. There are no exploding insect parts,
because the unit does not electrocute the insects. It utilizes a unique balance of the ultraviolet light as as attractant to
lure flying insects to the adhesive board. GT-200 operates silently and continuously, 24 hours per day. The insects
are captured and contained on the adhesive board for easy disposal. Note: The adhesive board should be changed as
least once a month.
To achieve optimal results from the GT-200 system, please read these instructions!
A Silent, Insect Control System is an important overall pest management program.
INSTALLATION
The following steps are a guideline to ensure proper installation:
Step 1.) Find location or source of insect problem, such as trash receptacles or compactors.
For optimal results, install the unit below eye level.
Step 2.) For mounting; locate solid wall structure for placement of unit.
•
Note: GT-200 must be placed 5’ away from open food prep areas.
Units should be mounted lower than eye level.
Step 3.) Mark and drill pilot holes & affix mounting screws to match key slots on back of unit.
Step 4.) Mount the GT-200 unit onto the wall by aligning the key slots to screws.
Step 5.) Install the adhesive boards into unit.
GROUNDING INSTRUCTIONS
1.)
The product is equipped with an appropriate 3-conductor cord and a 3-prong grounding type plug to fit the
proper grounding type receptacle. To reduce the risk of an electric shock, the plug must be plugged into an
appropriate outlet that is properly installed and grounded:
Consult a qualified electrician or serviceman if the grounding instructions are not completely understood, or if doubt
as to whether proper grounding exists.
2.)
Extension Cords
Use only a 3-wire extension cords which have 3-prong grounding type plugs and 3-pole receptacles which
accept the product’s plug. Replace or repair damaged cords.
