![background image](http://html1.mh-extra.com/html/gardner-denver/l30rs/l30rs_user-and-service-manual_3856720026.webp)
6. Transport and installation
24
6
Trans port and installation
6.1
Transport
DANGER
The compressor or parts of it may fall if
mistakes are made when lifting, and this will
put your life at risk. Safety devices my be
damaged if lifted incorrectliy.
•
Always observe the safety notes in
Section 4.5 of the user manual.
•
Never lift the compressor by or tie onto
its enclosure.
•
A suitable fork lift which complies with
local safety regulations must be used
when lifting the compressor.
•
The fork length of the fork lift must
correspond to the unit width (see
Section 12.2).
•
Keep the distance between the forks
(see Fig. 6) and their length in mind
when transporting the compressor.
•
All loose parts or parts which can swing
freely must be safely secured before the
unit can be lifted.
•
It is strictly prohibited to stand in the
danger zone of a lifted load.
•
Ensure that the transport load approach
is performed properly (according to the
user manual of the lifting device).
NOTICE
Before transporting, the R-clips (-1- Fig. 7 and
the doors must be removed.
Only use the appropriately marked lifting points.
Shifting the system after it is lowered is not
permitted.
Fig. 6
Fig. 7
1
R-clip
2
Hinge pin
Weights
The values listed below are approximate values, they
refer to a screw compressor unit including oil fill:
L30
2061 lbs
L30RS
2039 lbs
L37
2157 lbs
L37RS
2099 lbs
L45
2206 lbs
L50
2356 lbs
L45RS
2147 lbs
Summary of Contents for L30RS
Page 2: ......