Gardner Denver L Series, Original User And Service Manual, Page: 25 / 60

13-25-639 v00 Page 24
DANGER
6.1 Transport
Fig. 5
Fig. 6
Weights
The values listed below are approximate values, they
refer to a screw compressor unit including oil fill:
Air-cooled unit
L90 A 5551 Ibs
L110 A 5860 Ibs
L132 A 6124 Ibs
L90RS A 6102 lbs
L110RS A 6107 lbs
L132RS A 6142 lbs
Water-cooled unit
L90 W 5251 Ibs
L110 W 5474 Ibs
L132 W 5736 Ibs
L90RS W 5719 lbs
L110RS W 5723 lbs
L132RS W 5754 Ibs
NOTICE
Before transporting, the R-clips (-1- Fig. 6 and
the doors must be removed.
Only use the appropriately marked lifting points.
Shifting the system after it is lowered is not
permitted.
The compressor or parts of it may fall if
mistakes are made when lifting, and this will
put your life at risk. Safety devices may be
damaged if lifted incorrectly.

Always observe the safety notes in
Section 4.5 of the user manual.

Never lift the compressor by or tie onto
its enclosure.

A suitable fork lift which complies with
local safety regulations must be used
when lifting the compressor.

The fork length of the fork lift must
correspond to the unit width (see Section
12.2).

Keep the distance between the forks (see
Fig. 5) and their length in mind when
transporting the compressor.

All loose parts or parts which can swing
freely must be safely secured before the
unit can be lifted.

It is strictly prohibited to stand in the
danger zone of a lifted load.

Ensure that the transport load approach
is performed properly (according to the
user manual of the lifting device).
