![background image](http://html1.mh-extra.com/html/gardner-denver/heliflow-8-series/heliflow-8-series_owners-manual_3665514046.webp)
HF-7-604 Page 45
13. Slinger and Nut Installation - Vertical Configuration
NOTICE
The oil slingers must be installed on the bottom shaft. Assure the slingers are installed on the drive and gear
ends. The drive end slinger is smaller in diameter than the gear end slinger.
68.
Position the assembly vertically with the gear end on the top.
69.
Install a spacer (20 ) onto both of the rotor shafts of the gear end.
70.
Install the oil slinger (43) on the bottom rotor shaft. In order to be in contact with the oil, the
slinger must be installed on the bottom shaft.
71.
Install a bearing locknut (23) on each rotor shaft on both ends. Apply Loctite246 (45) to the locknut
threads prior to screwing it onto the shaft. Use locknut tool (T12) and a torque wrench to tighten the
locknut to 250-lbs.
72.
Reposition the assembly vertically with the drive end on the top.
73. Install a spacer (19) onto both rotor shafts on the drive end.
74.
Install the oil slinger (21) on the bottom shaft of the drive end. In order to be in contact with the oil,
the slinger must be installed on the bottom shaft.
75. Repeat step 71 to install the bearing locknut.
Summary of Contents for HELIFLOW 8 Series
