Gardner Denver HELIFLOW 8 Series, Owner'S Manual

Page: 28 / 64

HF-7-604 Page 27
SECTION 5
SPECIAL TOOL REQUIRED
All Tools Required for Disassembly and Assembly
Item
T1 Part Number
50B8Z Qty
1
Description
3/4-10UNC Heavy Hex
T2 95A8Z 1 3/4” Flat Washer
T3 TST000135 1 3/4-10UNC All Thread
T4 307CRL074 1 Hydraulic Pump Injector
T5 668RMCA30Z 1 M30 Hex Nut
T6 308CRL074 1 Gear Washer Tool
T7 303CRL450 1 Rod Bushing
T8 318HYG074 1 Adapter,MG3/4 x F3/4-
T9 655EE070 7 SCREW ,1/2-13UNC x
T10 316HYG074 2 Timing Wedge Tool
T11 313HYG074 1 Bearing Housing Dis.
T12 300HYG074 1 Rotor Nut Driver Tool
T13 315HYG074 1 Ring Carrier Puller Tool
T14 303HYG074 1 Ring Compressor Guide
T15 307HYG074 1 Bearing Insert Tool
T16 306HYG074 1 Oil Slinger Insert Tool
T17 304HYG074 1 Seal Insert Tool
T18 302HYG074 1 Drive Shaft Cover Seal
T19 655EC040 2
Tool
Screw,1/4-20UNC x
T20 305HYG074 1 Sump Cover Alignment
T21 314HYG074 1 Gear Driver Tool
T22 308HYG074 1 Driver Tool (Mul -Use)
T23 309HYG074 1 Insert Installation Tool
T24 319HYG074 1 Bearing Housing Dis.
*T25 TEN001430 1 SKF Oil Injector Kit
(729101/300MPA)
*T26
Part of T25 Kit
1 SKF Hydraulic Tube
T27 TEN001429 1 Piston Ring Expander
+T28 TEN001154 2 Hydraulic Cylinder
RCH-202)
T29 301HYG074 1 False Bearing Tool
T30 312HYG074 1 Insert ExtractionTool
T31 15P34 1 Eyebolt,3/4-
10UNCx2.00LG
*
Tools T25 and T26 are supplied as part of “SKF Oil
Injector Kit 729101”. This kit can be purchased from
an authorized Gardner Denver or SKF distributor.
+
Enerpac hydraulic cylinder tool T28 is sold
separately. It must be used with a hand pump or
electric pump which can be purchased from an
authorized Enerpac distributor. Tool T28 can be
purchased from Enerpac as a set (SCH-202H)
which includes a RCH202 cylinder, hand pump, 6
hose, calibrated gauge with adapter.