![background image](http://html2.mh-extra.com/html/gardner-denver/5cdl-r-series/5cdl-r-series_parts-list-operating-and-service-manual_5060201037.webp)
37- 1- 613 Page 36
SECTION 6
DISASSEMBLY INSTRUCTIONS
FIGURE 6- 1 – ADAPTOR PLATE
FIGURE 6- 2 – BEARING PRESS PLATE
Illustrations for Disassembly Instruc-
tions are taken from various sizes of
CycloBlower. Minor variations in
construction of some parts need
cause no concern.
1.
Provide adaptor plate, FIGURE6 - 1, for pulling
the
gear hub and pinion gear. Pulling directly on
pinion teeth will damage teeth making timing
difficult and will cause gear wear. Pulling directly
on the gear hub flange will distort the flange
causing gear run- out. The adaptor plates shown
are designed for a jaw type hydraulic puller,
FIGURE6-4 and FIGURE6-5.
Other type pullers are available, and if used, suit-
able adaptor plates should be provided.
2.
Provide bearing press plate, FIGURE6-2, for
pressing out rotors and installing bearings.
FIGURE 6- 3
–
SPANNER WRENCH
FIGURE 6- 4