Gardeo GSEBR900-2IN1, Original Instructions Manual

Page: 40 / 47

TROUBLESHOOTING
FAULT CAUSE REMEDY
Motor does not run
No electricity Check socket, cable and plug .
Running out of carbon brush
Damaged cable: Have repaired by
Customer Service. It is prohibited to
patch the cable with insulating tape.
Damaged switches have to be
replaced by a Customer Service
workshop.
Poor cutting performance
Blunt chain
Change the carbon brush, ask a
Customer Service workshop
Chain tension Sharpen the chain
Check that the chain is
fitted correctly
Chain wrongly fitted
Saw works only with difficulty
Chain tension
Check the chain tension
Chain jumps off sword Check the chain tension
Chain becomes hot Chain lubrication Check oil level
SPECIFICATIONS TECHNIQUES
Rated input voltage 230-240V~, 50 Hz
Input power 900 W
Speed 29600 min-1
Safety class II
Chain speed 15 m/s
Weight (without guide rail and chain) 3.1kg
Weight (with guide rail and chain) 5kg
Oiltank 100ml
Chain 91PJ040X
Chain bar 10’’ (250cm)
Cutting length 10’’(190mm)
Number of chain drive links 40
Chain width 1.3 mm
Teeth of the sprocket chain wheel 5
Values of noise emissions measured by the
standard:
Acoustic pressure level LpA
93.7 dB(A) K = 2.42 dB(A)
Acoustic power level LwA
105.1dB(A) K = 2.42 dB(A)
estimated guarantee LwA 108 dB(A)
ATTENTION !
The sound power pressure may
exceed 85 dB(A), in this case
individual hearing protection
must be worn.
Weighted root mean square acceleration according
to relevant standard
Front handle:6,488 m/s²
K = 1,5 m/s²
Rear handle: 5,981m/s² K = 1,5 m/s²
The declared vibration total value has
been measured in accordance with a standard
test method and may be used for comparing one
tool with another that the declared vibration total
value may also be used in a preliminary
assessment of exposure.
A warning that the vibration emission
during actual use of the power tool can differ
from the declared total value depending on the
ways in which the tool is used and of the need to
identify safety measures to protect the operator
that are based on an estimation of exposure in
the actual conditions of use (taking account of
all parts of the operating cycle such as the times
when the tool is switched off and when it is
running idle in addition to the trigger time).