28
4. Switch on the motor only when hands and feet
are away from the cutting tool.
5. Before starting make sure that the cutting tool
has no contact with hard objects such as branches,
stones etc. as the cutting tool will revolve when
starting.
Method of operation
1. Never operate the machine with damaged
guards or without the guards in place.
2. Only use the tool in good light and visibility.
During the winter season beware of slippery or
wet areas, ice and snow (risk of slipping). Always
ensure a safe footing.
3. Take care against injury to feet and hands from
the cutting tool.
4. Keep hands and feet away from the cutting
means at all times and especially when switching on
the motor.
5. Never cut above waist height.
6. Never stand on a ladder and run the tool.
7. Never work on unstable surfaces.
8. Don’t overreach. Keep proper footing and
balance at all times.
9. Remove sand, stones, nails etc. found within the
working range. Foreign particles may damage the
cutting tool and can cause to be thrown away,
resulting in a serious injury.
10. Should the cutting tool hit stones or other hard
objects, immediately switch off the motor and
inspect the cutting tool.
11. Before commencing cutting, the cutting tool
must have reached full working speed.
12. During operation always hold the tool with both
hands. Never hold the tool with one hand during
use. Always ensure a safe footing.
13. All protective equipment such as guards and the
shoulder strap supplied with the tool must be
used during operation.
14. Except in case of emergency, never drop or cast
the tool to the ground or this may severely
damage the tool.
15. Never drag the tool on the ground when moving
from place to place, the tool may become
damaged if moved in this manner.
16. Always remove the battery cartridge from the
tool:
- whenever leaving the tool unattended;
- before clearing a blockage;
- before checking, cleaning or working on
the tool;
- before making any adjustments,
changing accessories or storing;
- whenever the tool starts vibrating
unusually.
17. To cut thick materials, such as weed, high
grass, bushes, shrubs, underwood, thicket etc.
(max. 2 cm dia. thickness), perform the cutting work
by swinging the tool evenly in half-circles from right
to left (similar to using a scythe).
18. Don’t force the tool. It will do the job better and
with less likelihood of a risk of injury at the rate for
which it was designed.
Maintenance instructions
1. The condition of the cutting tool, protective
devices and shoulder strap must be checked
before commencing work.
2. Turn off the motor and remove the battery
cartridge before carrying out maintenance,
replacing the cutting tool and cleaning the tool.
3. After use, disconnect the battery cartridge from
the tool and check for damage.
4. Check for loose fasteners and damaged parts
such as nearly cut-off state halfway in the cutting
tool.
5. When not in use store the equipment in a dry
location that is locked up or out of children’s
reach.
6. Use only the manufacturer’s recommended
replacement parts and accessories.
7. Never use replacement parts or accessories not
provided or recommended by the manufacturer.
8. Always ensure that ventilation openings are kept
clear of debris.
9. Inspect and maintain the tool regularly,
especially
before/after use. Have the tool repaired only by
our authorized service center.
10. Keep handles dry, clean and free from oil and
grease.
11. When not in use store the machine out of the
reach of children.
SAVE THESE INSTRUCTIONS.
