Line feeding
During use, the tip of the trimming line will get shorter due to
wear. Regularly check the condition of the trimming line and adjust
if necessary. The line spool is equipped with a bumper helping to
cut the trimming line while operating.
1. Tap the bumper on solid ground and the spool will release
trimming line.
2. Excess line will be cut by the knife and should always remain
inside the radius of the guar.
Plant protector
Use the plant protector to keep distance to plants like flowers or
trees as well as other obstacles that could be hit by the cutting
device.
1. Fold the plant protector out for trimming / edging operation.
2. Fold the plant protector infor storage.
WARNING! Adjust the plant protector position only when the
product is switched off and the cutting device is at a complete
stop!
Trimming
1. ENSURE THE KNIFE PROTECTOR LABEL IS REMOVED BEFORE USE
2. Adjust the trimmer head angle to 0° for trimming operation.
3. Hold the product firmly with a gap between the product and
your right side.
4. Stand upright, do not lean forward and pay attention to
posture. Keep both feet apart to help retain your balance.
5. Hold the trimmer head just above the ground at an angle of
approximately 30° (Fig 13).
6. Move the product with a slow regular arc from left to right
before moving it back to the starting position before trimming
the next area (Fig 14).
19
Fig 14
30
o
Fig 13
www.coreservice.co.uk
AFTER SALES SUPPORT
IRE
GB
01904 727501
019022605
MODEL: GLGT400, 04/15, 64887
Summary of Contents for GLGT400
Page 31: ...GLGT400 04 15...
