10
Vibration and noise reduction
To reduce the impact of noise and vibration emission, limit the
time of operation, use low-vibration and low-noise operating
modes as well as wear personal protective equipment.
Take the following points into account to minimize the vibration
and noise exposure risks:
1. Only use the product as intended by its design and these
instructions.
2. Ensure that the product is in good condition and well
maintained.
3. Use correct cutting device for the product and ensure they in
good condition.
4. Keep tight grip on the handles/gripping surface.
5. Maintain this product in accordance with these instructions
and keep it well lubricated (where appropriate).
6. Plan your work schedule to spread any high vibration tool use
across a longer period of time.
Emergency
Familiarise yourself with the use of this product by means of this
instruction manual. Memorise the safety directions and follow
them to the letter. This will help to prevent risks and hazards.
1. Always be alert when using this product, so that you can
recognise and handle risks early. Fast intervention can prevent
serious injury and damage to property.
2. Switch off and disconnect from the power supply if there is
any malfunction. Have the product checked by a qualified
specialist and repaired, if necessary, before you put it into
operation again.
Residual risks
Even if you are operating this product in accordance with all the
safety requirements, potential risks of injury and damage remain.
The following dangers can arise in connection with the structure
and design of this product:
1. Health defects resulting from vibration emission if the product
is being used over long periods of time or not adequately
managed and properly maintained.
2. Injuries and damage to property due to broken application
tools or the sudden impact of hidden objects during use.
3. Danger of injury and property damage caused by flying
objects.
www.coreservice.co.uk
AFTER SALES SUPPORT
IRE
GB
01904 727501
019022605
MODEL: GLGT400, 04/15, 64887
Summary of Contents for GLGT400
Page 31: ...GLGT400 04 15...