4 Stroke Petrol Lawn Mower
AFTER SALES SUPPORT
e-mail: [email protected]
1800 909 909
MODEL: №.
DM46P-DO140 • 08/2017 • 57774
(toll free)
18
AFTER SALES SUPPORT
(toll free)
4 Stroke Petrol Lawn Mower
e-mail: [email protected]
1800 909 909
MODEL: №.
DM46P-DO140 • 08/2017 • 57774
Adding and Checking the oil
IMPORTANT:
The motor of this mower is packed with NO OIL in the motor.
Prior to starting the motor, Oil MUST be added to the sump of the motor.
O
covered under the warranty of the mower.
On a new mower, the motor needs to be filled with 350ml of SAE 10W/30
engine oil.
Each time the mower is used, the oil level should be checked and if low, add
17
1. Position the lawn mower on a flat and level surface. Clean the area directly
around the oil filler cap (17).
2. Remove the oil filler cap (17) by unscrewing it in an anti-clockwise
direction, and lift the cap outwards (Fig M).
Clean the oil dipstick (17) with a clean cloth, cleaning away any visual oil.
NOTE:
The cap is a full threaded fit.
3. FOR A NEW MOWER, add 350ml of SAE 10W/30 engine oil. Before replacing
the dip stick / filler cap, allow a minute or so to allow the oil in the filler tube
to fully drain of oil.
4. For both a new mower and also a previously used mower, measure the
amount of oil in the motor by re-inserting the oil dipstick back on top of
the filler tube, BUT DO NOT screw the cap in place.
5. After a few seconds, remove and inspect the oil level on the bottom of the
oil dipstick (17). (Fig N)
6. The oil level should be between the low and maximum marked section of
17
O
inserting and screwing back in the oil filler tube in a clockwise direction
until firm.
7
the oil dipstick (17), add further oil in 50ml intervals and repeat steps 4, 5, 6,
and 7 until the correct oil level is obtained.
Always ensure the oil filler cap (17) is firmly locked in place before the
motor is started. Do not over fill with oil above the maximum mark.
Only use SAE 10W/30 engine oil.
N.
O.
HIGH
LOW
CORRECT
LEVEL
Adding and checking the oil
M.
TIGHTEN
LOOSEN
