Congratulations on your purchase of a ne
w
greenhouse.
BEFORE YOUSTART
1. Thank you for selecting our greenhouse. Please read the instructions carefully before starting work.
2. Please wear gloves during construction because the metal edges aresharp.
3. This greenhouse is for raising plants only and we cannot accept liability for any other use.
4. At least 2 people are required to install this greenhouse.
5. Please contact us if you encounter problems during theinstallation.
6. Do not force the components together.
7. Position your greenhouse in a sunny spot which is sheltered fromstrong winds.
8. Make sure that doors and roof vents are closed in windy weather.
9. Make sure your greenhouse is covered by your household insurance policy.
10. Polycarbonate may be adversely affected by many chemicals including acids, ammonia,cement,iodine,
methanol and petroleum.
11. Use warm soapy water and mild detergents when you wash your greenhouse.
IMPORTANTINFORMATION
1. Use the parts list to check that all components are present before you start work.
2. The main components are labeled with the part number.
3. The parts list includes drawings which show the shape of each profile.
4. Please contact us if any parts are missing.
BASE PLINTH ASSEMBLY – see Page1
1. Page 1 of the instructions shows how to assemble the base plinth.
2. The base plinth must be level and square to ensure a sound foundation for your greenhouse.
3. Figure 1 and Figure2 Figure 3 inset show how to install the base clips.
4. The base clips should be hooked over the base and bolted to the glazing bars to ensure that the
greenhouse is securely fixed to the base plinth.
5. It is important that every base clip is installed especially at a site which may be subject to strongwinds.
6. We recommend that the base plinth is securely anchored into the ground especially at a site which
may be subject to strong winds. The corner pegs can be set in concrete or the underside of the
base can be fixed into a patio or concrete using expanding bolts or screws andplugs.
REAR WALL ASSEMBLY – see Page2
1. Page 2 of the instructions shows how to assemble the rear wall.
2. Pack 1 includes the main components required to assemble the rear wall.
3. Loosely connect the main components with all bolts finger tight only.
4. Figure 1.2.Before fixing the vertical glazing bars slide extra bolts into the bolt channels as required
to fix the braces later. If you forget this you can disconnect the glazing bars later and add the extra bolts
but it takes longer.
FRONT WALL ASSEMBLY – see Page3
1. Page3 of the instructions shows how to assemble the front wall.
2. Pack2 includes the main components required to assemble the front wall.
3. Loosely connect the main components with all bolts finger tight only.
4. Figure2.2.Before fixing the vertical glazing bars slide extra bolts into the bolt channels as required to fix the
braces later. If you forget this you can disconnect the glazing bars later and add the extra bolts but it takes
longer.
