Assembling the Light Fixture
Important:
Before installing the Ballasts, remove the T-5 Light Tubes by twisting them gently out of the sockets. Set them aside for
now. The Light Tubes are fragile and may break if left inside the ballasts during installation.
Step 1.
Place a Light Fixture Hood upside down on a level surface.
This will reveal the Ballast Clips inside (Figure 4).
Step 2.
Locate the Ballasts and note that each end has an open
pin (female) and closed pin (male) socket.
Important:
Place the
Ballasts into the Hood so that each end of the Light Fixture has
a male and female socket. Push a Ballast into each set of Clips,
making sure to center the Ballasts in place (Figure 4).
Step 3.
Plug the 6' Electrical Cord into the male end of one Ballast.
Tip:
Orient all Electrical Cords to one end of the SunLite Garden
as you assemble each Fixture.
Step 4.
On the opposite end of the Light Fixture, use a Link Cord to
connect the two Ballasts. Snap it firmly into place. If it does not
fit, make sure the Ballasts are positioned with one male and one
female socket at each end of the Light fixture.
Step 5.
Replace the Light Tubes by sliding the pins on the Tube into the Ballast sockets, then rotate it 0 degrees until it “locks” into
place. Installing the Tubes correctly will ensure they produce the most light. Do not force the Tubes into place. Turn the Light
Fixture Hood upright and remove the protective film from the black side of it. Repeat Steps 1-5 for each Light Fixture Hood.
Ball Chain Assembly
Step 1.
Attach a Chain Connector to each Split Ring (Figure 5, detail). If necessary, use needle-nose pliers to pry open the Split Rings.
Step 2.
Connect one end of a Ball Chain to the Chain Connectors on the Split Rings. The last ball of the chain will “snap” onto the
connector.
Step 3.
Take the loose end of each Ball Chain and thread it through a Chain Grip (Figure 5). Then, thread the Ball Chain through the
drilled hole in the S2 Vertical Bar and over the Spacer, as shown in Figure 5.
Tip:
To make it easier to install the Ball Chains, tip the
assembled Frame onto its side so that the chain drops down into the hole and over the spacer. Repeat to install the Ball Chains on
both sides and all tiers of the Frame.
Step 4.
Place Poly trays and assembled Light Fixtures onto each tier of the Frame. Attach the Ball Chains to the Light Fixtures by
snapping the last ball of each Ball Chain into the Chain Connectors that are pre-installed on the top of each Light Fixture.
instructions continue, over please
Ballast
Clip
closed pin
socket
open pin
socket
Ballast
Underside of Hood
Figure 4
Remove Light
Tubes before
installing
Ballasts
Chain snaps into
Connector on top
of Hood
Figure 5
A3 horizontal bar, inside view
Spacer
Ball Chain
Guide Hole
Split Ring
Chain
Connector
S2 vertical bar
Pull chain out in a horizontal
direction.
Chain Grip
