Step 3.
Using a 2” bolt, attach an S3B Bar to the bottom of the S2 Vertical
Bar (Figure 2).
Step 4.
Connect an S1L and an S1R Vertical Bar to the ends of the S3B
(Figure 2).
Important:
Insert the bolt through the large hole in the
vertical bar first, then the small hole, then the nut, so that your
screwdriver is inside the bar when tightening. The head of the bolt
will be flush against the inside wall of the S1L and S1R Bars when
tightened. Attach the S3T between the S1L and S1R (Figure 1). You
have just finished the first Side Frame.
Step 5.
Repeat Steps 2 through 4 to assemble the second side frame,
then firmly tighten all bolts on both Side Frames, making sure the
bars are flush with one another.
Important:
Assemble both sides before proceeding.
Step 6.
Connect the ends of an A3 Bar between the top S3T Bars (Figure
3). The open track of the A3 Bar should face toward the ground. Insert
the bolts through the predrilled holes in the S3T bars, then screw the
bolts into the ends of the A3 Bar on both ends (Figure 3). Connect the
remaining A3 Bar(s) to the S2 Vertical Bars at each tier.
Note:
Figure 3
shows the 2-Tier Compact SunLite
®
Garden only.
•
2-Tier Compact SunLite
®
Garden has two A3 Bars.
•
3-Tier Compact SunLite
®
Garden has three A3 Bars.
Step 7.
Connect the A4 Shelf Bars to the S1L and S1R
Vertical Bars at each tier (Figure 3). Each A4 Shelf Bar
is box-shaped with a thin flange. Make sure the wide
flat side of the flange is flush with the outside of the
S1 Bars on each side and pointing toward the top of
the unit. The box-shaped portion of the Shelf Bars
are positioned inside to hold the Poly Trays (Figure
3).
Note:
Figure 3 shows the 2-Tier Compact SunLite
Garden only.
•
2-Tier Compact SunLite
®
Garden has four A4 Shelf
Bars.
•
3-Tier Compact SunLite
®
Garden has six A4 Shelf
Bars.
Step 8.
You may now tighten all bolts on the frame,
holding the bars in place as you tighten. With the frame
upright, make sure all outside edges of the bars are
flush and secure. Adjust, as necessary.
Step 9.
Gently lay the entire frame on its side. Place a
Caster Insert into the bottom of all four S1 Vertical Bars.
Firmly push a Caster into each insert until it clicks into
place (Figure 3). Use a mallet, if needed.
Step 10.
Stand the unit upright. Cover all the bolt holes
with Bolt Caps (Figures 1 and 2). Place Poly Trays on
the A4 Shelf Bars. The frame assembly is finished.
2" Bolt
Bolt Cap
2" Bolt
Figure 2
S3B
Bottom of S1 bars
have 4 bolt holes
Side Frame Assembly — Bottom
Note:
Larger
hole
faces
outside
of frame.
Figure 3
Caster Insert
Caster
S3T
S3T
S3B
S3B
Box side of A4 Shelf Bars
face inside and the thin
flanges are positioned up
and flush with the outside of
the frame.
Note: Illustration shows 2-Tier
SunLite. The 3-Tier has an additional
set of A3 and A4 parts and bolts.
Shelf Bar
Bolt Cap
