15
(1) Oil
(2) Fuel
(3) Engine switch
(4) Choke knob
4.
Pull out the choke knob. The choke will
close and the throttle lever will then be set in
the starting position.
When restarting immediately after stopping the
engine. Set choke in the open position
Once the choke knob has been pulled out, it
will not return to the operating position even if
you press down on it with your finger. When
you wish to return the choke knob to the
operating position, pull out the throttle lever
instead.
5. While holding the saw unit securely on the
ground, pull the starter rope vigorously.
6. When firing occur, push in the choke knob
and pull the starter again to start the engine.
7. Allow the engine to warm up with the throttle
lever pulled slightly.
Before you start the engine, make sure the
saw chain is not contacting anything.
■
CHECKING OIL SUPPLY
6.
Operation
Summary of Contents for GC3814
Page 35: ...34...
