15
6.
Operation
■
STARTING ENGINE
1. Untwist and remove the fuel cap. Rest the
cap on a dustless place..
2. Put fuel into the fuel tank to 80% of the full
capacity.
3. Fasten the fuel cap securely and wipe up
any fuel spillage around the unit.
4.
Put the switch to the "I" position.
5.
Continuously push the priming bulb until fuel
comes in the bulb.
(1) Oil
(2) Fuel
(3) Engine switch
(4) Choke knob
4.
Pull out the choke knob. The choke will
close and the throttle lever will then be set in
the starting position.
When restarting immediately after stopping the
engine. Set choke in the open position
Once the choke knob has been pulled out, it
will not return to the operating position even if
you press down on it with your finger. When
you wish to return the choke knob to the
operating position, pull out the throttle lever
instead.
5. While holding the saw unit securely on the
ground, pull the starter rope vigorously.
