CAUTION: Do not make sharp
bends when you install the
boundary wire.
CAUTION: For careful operation
without noise, isolate all obstacles
such as trees, roots and stones.
3.3.3.1 To put the boundary wire in a slope
•
For slopes steeper than 35% inside the work
area, isolate the slope with boundary wire.
•
For slopes steeper than 15% along the outer
edge of the lawn, put the boundary wire 20
cm / 8 in. (A) from the edge.
•
For slopes adjacent to a public road, put a
fence or a protective wall along the outer
edge of the slope.
A
>15%
3.3.3.2 Passages
A passage is a section that has boundary wire on
each side and that connects 2 work areas. The
passage must be a minimum of 60 cm / 24 in.
wide.
Note: If a passage is less than 2 m / 6.5 ft. wide,
install a guide wire through the passage.
3.3.3.3 To make an island
•
Put the boundary wire to and around the
obstacle to make an island.
•
Put the 2 sections of boundary wire that run
to and from the obstacle together.
•
Put the 2 sections of boundary wire in the
same stake.
0 cm / 0"
CAUTION: Do not put a section of
boundary wire across the other.
The sections of boundary wire
must be parallel.
CAUTION: Do not put the guide
wire across the boundary wire, for
example a boundary wire that
goes to an island.
3.3.3.4 To make a secondary area
Make a secondary area if the work area has 2
areas that are not connected with a passage.
•
Put the boundary wire around the secondary
area (B) to make an island. The work area
with the charging station is the main area
To make an island on page 17.
1025 - 001 - 23.01.2019
Installation - 17
