ENGLISH - 2
Safety
check for signs of wear or damage and repair as
necessary.
4. Replace worn or damaged blades together with
their fixings in sets (4080-20) to preserve balance.
Use
1. Use the product only in daylight or good artificial
light.
2. Avoid operating your product in wet grass, where
feasible.
3. Take care in wet grass, you may lose your footing.
4. On slopes, be extra careful of your footing and wear
non-slip footwear. Do not mow on excessively steep
slopes.
5. Operate your product across the face of slopes,
never up and down.
6. Exercise extreme caution when changing direction
on slopes. Walk never run.
7. Make sure you always take up a safe and stable
stance whilst working, especially on slopes. Do not
use the mower close to swimming pools or garden
ponds.
8. Do not walk backwards when operating, you could
trip.
9
. Never cut grass by pulling the product towards you.
10. Switch off before pushing the product over surfaces
other than grass.
11. Never operate the product with damaged guards or
without guards in place.
12. Switch on the motor according to instructions and
with feet well away from the blade(s).
13. Do not put hands or feet near or under rotating
parts.
14. Never pick up, carry or tilt a product when it is
operating or still connected to the mains supply.
15. Remove the plug from the mains :
- before leaving the product unattended for any
period;
- before clearing a blockage;
- before checking, cleaning or working on the
appliance;
- if you hit an object. Do not use your product until
you are sure that the entire product is in a safe
operating condition.;
- if the product starts to vibrate abnormally. Check
immediately. Excessive vibration can cause injury.
Maintenance and storage
1. Caution: Do not touch rotating blade(s)
2. Keep all nuts, bolts and screws tight to be sure the
product is in safe working condition.
3. Check the grassbox frequently for wear or
deterioration.
4. Replace worn or damaged parts for safety.
5. Only use the replacement parts specified for this
product.
6. Be careful during adjustment of the product to
prevent entrapment of the fingers between moving
blades and fixed parts of the machine.
7. Store in a dry place and out of reach of children. Do
not store outdoors.
Warning! This machine produces an electromagnetical
field during operation. This field may under some
circumstances interfere with active or passive medical
implants. To reduce the risk of serious or fatal injury, we
recommend persons with medical implants to consult
their physician and the medical implant manufacturer
before operating this machine. Do not use the product
when a thunderstorm is approaching.
Danger! Small parts could be swallowed during
assembly and there is a risk of suffocation from the
polybag. Keep infants away during assembly.
Where to Use Your GARDENA PowerMax 32 E Mower
The GARDENA mower is designed for cutting
lawns in and around the garden.
Do not use the mower on a slope steeper than
20° maximum.
To prevent injury, the mower must not be used for
trimming bushes, hedges, shrubs, for cutting and
pruning of climbers or grass on roofs or in balcony
boxes. In addition, the mower must not be used
for chopping up branches, twigs or for levelling
irregularities in the soil.
Assembly Instructions
• The Loose Parts Pack is packaged underneath
the deck.
Assembly of Lower Handles to Deck
1. Pull the wing knob until the lower handle bolt
locks into position as illustrated in
fig A
.
2. Unscrew the wing knob
3. Place the bolt
(A )
through the hole in the lower
handle
(A )
until the lower handle fits into the
recess
(A )
.
4. Place the washer
(B )
and the wing knob
(B )
on to the bolt and tighten the wing knob.
5. Repeat on the other side.
Assembly of Upper Handle to Lower Handle.
1. Ensure the upper handle is located correctly with
the lock-off button on the switchbox uppermost.
2. Ensure the upper handle
(C )
and the lower
handle
(C )
are aligned correctly.
3. Fit the bolt
(C )
, washer
(C )
and wing knob
(C )
. Tighten the wing knob.
4. Repeat on the other side.
5. Fit the cable to the handles with the clips
provided. Make sure the cable is not trapped
between the upper and lower handles.
Grassbox Assembly
1. Slide the grassbox tongue into the slots in the
grassbox lower until it clicks securely into
position
(D)
2. Push the grassbox handle into the slots in the
grassbox upper until it clicks securely into
position.
(E)
3. Starting at the rear of the grassbox, locate the
grassbox upper into the grassbox lower by
aligning the clips
(F )
. Ensure all clips are
correctly located
(F )
before clicking into position.
4. Clip the two halves together, ensuring all clips are
securely connected.
2
1
3
1
2
1
2
3
4
5
1
2
4073-20.960.02 GARDENA 32 E Euro.qxp_Gardena 32E 30/04/2015 11:40 Page 12
