0
q
8
9
ß
S
7
1. Unscrew the cross-head screws
9
and remove the suction
base
8
from the pump.
2. Press snap hooks
ß
S
together and remove safety cover
7
from
suction foot
8
and clean.
3. Clean suction foot
8
and impeller
0
.
4. Refit suction foot
8
and screw in the cross-head screws
9
again.
During this, ensure that the sealing ring
q
is seated correctly.
5. Reinsert the safety cover
7
in the suction foot
8
again.
For safety reasons a damaged feed impeller
0
can only be
exchanged by the GARDENA Service Centre.
7. Troubleshooting
WARNING! Electric shock!
Risk of injury due to electric shock.
v
Disconnect the pump from the mains before
rectifying faults.
Problem
Possible Cause
Remedy
Pump is running,
but does not deliver
Air cannot escape as pressure
line is closed
(e. g. kinked pressure pipe).
v
Open pressure line.
Air locks in the suction base.
v
Wait for max. 60 seconds
until the pump deaerates
automatically over the vent
valve. If necessary, switch
off and start it again.
Feed impeller clogged.
v
Disconnect plug and
clean feed impeller
(see 6. Cleaning).
When starting the pump,
water height falls below the
minimum water level.
v
Submerge pump deeper
into water.
Pump doesn’t start or
suddenly stops during
operation
Thermal overload switch has
switched the pump off due to
overheating.
v
Disconnect plug and
clean feed impeller
(see 6. Cleaning).
Observe maximum water
temperature of 35 °C.
No power.
v
Check fuse and electrical plug
and socket connections.
Dirt particles are jammed in
the suction base.
v
Disconnect plug and clean
suction base (see 6. Cleaning).
Pump runs, but output
suddenly decreases
Suction base is clogged.
v
Disconnect plug and clean
suction base (see 6. Cleaning).
For any other malfunctions please contact the GARDENA service department.
Repairs must only be carried out by GARDENA service departments or specialist
dealers authorised by GARDENA.
15
GB
