Connecting the hose:
1
2
The universal fitting
1
llows connection of all the hoses listed in the
table above.
1. Screw L-piece
2
into the pump.
2. Cut off nipples of the universal
1
fitting which are not needed,
to match the hose connection.
3. Screw the universal fitting
1
onto the pump.
4. Connect the hose to the universal fitting
1
.
We recommend that 38 mm (1 1/2")- and 25 mm (1") hoses
should be fastened with an additional GARDENA hose clamp
Art. No. 7193.
Only for 13 mm (1/2") hose:
The universal fitting
1
can also be equipped with a GARDENA
Regulator Valve Art. No. 977 so that the contents of the out-
let line do not flow back through the pump after pumping. The
Regulator Valve can be ordered from your GARDENA dealer.
4. Operation
Automatic operation:
5
4
3
6
The float switch
3
turns the pump on automatically when the water
level exceeds the cut-in height and the water is pumped out.
The float switch
3
turns the pump off again as soon as the water
level falls below the cut-out height.
1. Stand the pump on a firm surface
– or –
use a rope attached through the bore hole in the carrying
handle
4
to immerse the pump in a well or shaft.
During automatic operation, ensure that the float switch
3
can
move freely.
2. Plug the power cable
5
into a mains socket.
Adjusting the Cutin and Cutout Height:
(Minimum depth for switching on and off, see 8. Technical Data.)
v
Push the cable of the float switch
3
into the float switch lock
6
.
Do not select a cable length that is too long or short to ensure
that the float switch can turn on and off properly.
The cable length between the float switch
3
and the float switch
lock
6
must always be at least 10 cm.
• The shorter the length of cable between the float switch
3
and
the float switch lock
6
, the lower the cut-in height and the higher
the cut-out height.
13
GB
