Garden Leisure Garden-696L, Owner'S Manual

Page: 17 / 24

14
COMPONENT OPERATION
SPA COMPONENT
OPERATION
AIR CONTROL VALVE
The air control valves (smaller valves) serve to
regulate the amount of air mixed with the water
when the jets are operational. Turn the air control
valves in one direction to increased jet action.
Rotating the air control in the opposite direction
to turn air off and allow the jets to work with water
only. Turn the air controls off when the spa is not
in use, this will prevent cold air from entering the
spa and will keep heating cost to a minimum. The
ozone jet, will always produce air bubbles when
pump is on.
DIVERTER VALVE
(WHEN EQUIPPED)
The diverter valve on your spa allows you to direct
the flow of water from the pump to one of two
combinations of jets. The function of the diverter
valve can best be learned by experimentation.
Turn the large valve all the way to one side or the
other to see which jets are on.
HYDROTHERAPY JETS
The hydrotherapy jets are recessed in the wall of
the spa. Rotate the large or medium jet faces to
turn the jets on or off. Turning a jet on or off will
increase or decrease the effects of any jets not in
the closed position.
OZONE GENERATOR
The ozone system enhances the quality of the spa
water when used to supplement the spa owner’s
regular water maintenance program. Contrary to
some information circulated throughout the pool
and spa industry regarding ozone systems, ozone
CAN'T be used as a single-source sanitizer, water
clarifier, anti-foamer, and mineral chelating agent.
A secondary source sanitizer must be used to
maintain 3.0 - 5.0 ppm of Free Available Chlorine
(FAC). Aquaterra recommends that a chemical
maintenance program based on recognized and
documented industry standards still be followed
when using an ozone purification system to assure
water sanitation and the highest quality purified
water.
WATERFALL
Your spa has a control valve to operate the
amount of flow through the waterfall from no
flow to a steady stream. This valve is next to the
waterfall. The waterfall will only work when the Jet
Pump is on. Rotate valve to turn on or off.
NOTE: Should any of the 3 waterfall streams stop
or the amount of flow becomes inconsittent, the
following is required:
1. Turn black cap ¼ turn counter-clockwise and
remove.
2. Remove O-Ring.
3. Using Needle Nose Pliers insert half in and
half out of center of nozzle, grab with pliers
and pull nozzle assembly out.
4. A clear plastic filter with small holes will still be
inside the hole, place hand over hole and turn
waterfall valve on slightly to have the water
push filter towards the top, if water doesn't
push it out into your hand use Needle Nose
Pliers and pull out while waterfall is OFF.
5. Turn waterfall on to remove any debris inside
waterfall hole then turn off. Clean any debris
clogging the clear filter holes with water only.
6. Attach clear filter to bottom of nozzle assembly
then insert assembly back into waterfall hole.
7. Attache O-Ring.
8. Place black cap back onto hole and turn
¼ turn clock-wise to complete cleaning
process.
MUSIC (WHEN EQUIPPED)
Your spa is equipped with a Bluetooth music
sound system that requires a bluetooth device to
pair up with the spa. To pair the spa and Bluetooth
device:
• Go to the Bluetooth settings on you device and
find in.stream 2 and press connect.
• Enter pin 5555 and press pair to sync your
device. You are now ready to play audio from your
device.