13
CONTROL PANEL OPERATION
DIAGNOSTIC LCD MESSAGE
Message Meaning
Action Required
No message on display.
Power has been cut off to the spa.
The control panel will be disabled until power
returns. Spa settings will be preserved until next
power up.
HL
The system has shut the heater off
because the temperature at the heater
has reached 48°C (119°F). Do not enter
the water!
DO NOT ENTER THE WATER. Remove the spa
cover and allow the water to cool down, then shut
power off and power your spa up again to reset the
system.
If spa does not reset, shut off the power to the spa
and call Customer Service.
AOH
Temperature inside the equipment
compartment is too high 90°C (194°F),
causing the internal temperature in
the control system to increase above
normal limits.
Open equipment compartment and wait until error
clears.
Prr
A problem is detected with the
temperature probe.
Call Customer Service.
OH
The water temperature in the spa has
reached 42°C (108°F). Do not enter the
water!
Remove the spa cover and allow the water to cool
down to a lower temperature. Call your Dealer or
service supplier if problem persists.
Hr
An internal hardware error has been
detected.
Call Customer Service.
FLO
No water flow is detected by the control
system but flow is expected.
Make sure that the jet pump is running and water
is flowing; check and clean filters; make sure water
valves are open; make sure spa has a proper
water level. If problem persists, call Customer
Service.
WARNING! SHOCK HAZARD! NO USER SERVICEABLE PARTS.
Do not attempt service of the control box. Contact Customer Service for assistance. Follow all owner manual
power connection instructions. Installation must be performed by a licensed electrician and all grounding
connections must be properly installed.
SETTING ECONOMY MODE
In Economy mode you are able to lower the set temperature
of the spa by 20º F (11º C) during a certain period of day
which is adjustable as well as the length of time. One of the
main reasons you might want to enable this feature at night
is to limit the amount of times the spa will automatically turn
on either because of calling for heat or sampling the water for
temperature.
NOTE:
If the Economy Mode set time is enabled during a filter
cycle, the filter cycle will NOT come on during the enabled time.
To enable the economy mode:
1. Press and hold
Light
button for 5 seconds until clock
hour is displayed, press
Light
button several more times
until EPx is displayed, x representing the state of the
mode (0=disabled, 1=enabled)
2. Press the
Up +/Down -
button to either enable or disable
the economy mode.
3. Press the
Light
button again to set the Economy Start
time. The display will show ESxx where "xx" represents
the hour at which the economy mode will become active.
Press the
Up +/Down -
button to set the hour you want
the mode to be enabled.
A dot after the ES represents AM.
NOTE:
The time may be set, however, if Economy is
disable - 0, the Economy Mode feature will Not come on.
4. Press the
Light
button again to set the Economy
Duration time. The display will show Edxx, "xx" representing
how long (in hours) you want the economy mode to be ON.
Use the
Up/Down
buttons to adjust the amount of hours.
FAHRENHEIT/CELSIUS SETTING
To change water temperature display to either Fahrenheit or
Celsius, press and hold
Light
button for 5 seconds until clock
hour is displayed, press
Light
button several more times until F
or C is displayed. Press the
Up/Down
button to change.
Summary of Contents for Garden-696L
Page 1: ...OWNER S MANUAL 50HZ...
Page 24: ...21 305314 24 A 9 23...