ASSEMBLY INSTRUCTION FOR PROTECTIVE NET
STEP 1: AND PUT TWO SECTIONS OF SUPPORT PIPES CONNECTED TOGETHER AS SHOWN
IN FIGURE 1. ATTACH A CAP AT THE END OF THE PIPES.
STEP 2: USING THE STEEL SCREW (SEE A1 AND A2). THE SUPPORT POLES SHOULD REACH
THE BASE OF THE TRAMPOLINE LEGS. ONCE THE ASSEMBLY HAS BEEN COMPLETED
PROPERLY, THE SUPPORT POLES SHOULD LOOK LIKE
FIGURE 4
A1
：
Fixing support pipes onto trampoline legs A2
：
Finished as shown A2.
with screw, spacer and tighten (Note : The screw need to through
them use nylon washer, screw set. the square hole of support pipes)
One support pipe need use two screw sets.
The
Screw Set
must be on the inside, underneath the trampoline. IMPORTANT - Do not attach the
Upper
Screw
to the “T” piece on the Frame. T
he
Screw
must be located on the leg only.
FIGURE 1
FIGURE 2
FIGURE 3
