●Slide the suc�on/blowing pipe into motor
housing 1(Fig.3).
●Tighten the 2 screws A (Fig.2 and 3).Make
sure the suc�on/blowing pipes are firmly
Closed with the motor housing(Fig.3).
●Assemble the Wheel Bracket: Insert the
wheel bracket from the end Lower tube �ll
It reach the rib posi�on and can not forward
again(Fig.4).
●Locate one screw in the screw hole on wheel
bracket �ghten the screw firmly(Fig.5).
To start the Vacuum-Blower ensure that the
intermediate suc�on/blower tube is fi�ed
correctly.
●Hold the pipe several cen�meters over the
leaves that you are going to suck up. Now
switch the applica�on on.
●Hold the applica�on as shown in Fig. 8b and
8c, �l�ng the Blower/Suc�on pipe slightly, and
use a sweeping ac�on to collect light debris
with a few inches distance between the
opening of Blower/Suc�on pipe and the floor or
ground to be clean up.
●The leaves will be sucked up into the pipe,
chopped up and thrown into the waste bag.
Tips:
Light dirty between the suc�on pipe,
motor housing and exhaust opening can be
moved by changing of the posi�on of the
Func�on switch from “
↑
” to “↓” or likely
several �mes.
CAUTION!
Always switch off the applica�on and pull the
plug out of the power socket, wait �ll the
applica�on stands�ll completely before
carrying out any work on
●Take care of your applica�on and clean it
regularly to obtain long-las�ng efficiency and
performance.
●When you have finished work, remove the
waste bag, turn it upside down and clean it
thoroughly.
●Keep the air vents clean and free from grass.
●Use only a warm damp cloth and a so� brush
to clean your applica�on.
●Never wet or spray water on the applica�on.
●Do not use detergents or solvents as these
could cause irreparable damage to your
applica�on. Chemicals can easily destroy the
plas�c parts.
●If vacuum power decreases and the bag is
empty, clean the shredding chamber carefully.
Troubleshooting
WARNING!
B
efore any maintenance work, first
unplug the applica�on from the mains.
●Applica�on does not start. Check the electri
-
cal connec�on and the posi�on of the switch
should be set on “1”.
●The blower func�on does not work. Check the
Func�on switch is set in the right posi�on.
●The suc�on func�on does not work. Check
that the Func�on switch is set in the right
posi�on. Remove any dirty from suc�on pipe
and empty the waste bag.
●The shredder wheel is blocked. Remove the
leaves that have been sucked up and empty the
waste bag. Check that if both internal and
external openings are clear. Remove any dirt
from the opening by using a wooden s�ck. A
piece of wood or stone, plas�c bag may result
damage of the shredder wheel. Should this
persist, contact the authorized service center
immediately.
WARNING!
B
efore selec�ng the suc�on or
blower func�on, ensure that the func�on
selector lever is working properly and that it is
not affected by dirt from previous use. Select
either the suc�on or blower func�on with the
selector lever on the side of the machine (7)
and press the bu�on (3). If more power is
needed, move the speed controller from
posi�on "1" to posi�on "6" (Fig. 10).
Stopping the Vacuum-Blower
To turn off the machine you can simply release
the switch.
Before star�ng the applica�on, make sure that
the waste bag is fi�ed and the shoulder strap is
adjusted to a suitable working posi�on.
Double insulation
The leaf blower has double insula�on. This
means that all external metal parts are insulat-
ed from the electrical supply.
This is achieved by introducing an insula�on
layer between electrical and mechanical parts.
The double insula�on guarantees you the
greatest possible safety.
Blowing (Fig. 7 and 8a)
Blow mode can be also used to clean corners,
fences, walls, wooden areas or beneath cars. Be
careful how you point the jet of air as it could
move heavy material and cause injury or
damage.
●Turn the Func�on switch an�clockwise to
posi�on “
↑
”
●Turn the switch to on, point the jet of air in
front of you and move forward slowly to
gather together the leaves or to move the
leaves from inaccessible areas.
Vacuum mode (Fig.7 and 8b)
●Set the Func�on switch clockwise to posi�on
“↓”. Make sure that the waste bag is fi�ed
properly.
www.DeubaXXL.de
www.DeubaXXL.de
12
13
