Part 3: Install the Eyelet Screw
NOTICE
If your MyLifter is mounted parallel to
the stud, the eyelet screw must be
placed on the same side as the unit's
power plug. This prevents the fully
raised cable from contacting the
MyLifter and causing cable damage.
NOTICE
If your unit is mounted perpendicular to
the stud, the eyelet screw must be
placed on the same side where the
cable comes out of the lifter (the side
where the cable hangs when it is fully
coiled). This prevents the fully raised
cable from contacting the MyLifter and
causing cable damage.
1. Use a stud finder to find the center of the stud.
2. Mark the center of the stud about two inches away from the lifter.
Placing the eyelet screw two inches from the lifter ensures that the cables will be
as straight as possible when the item is fully lifted.
3. Use a drill to drill a pilot hole at least three inches into the mark you made.
4. Use a screwdriver to turn the eyelet screw into the pilot hole.
