7
3”
9. SETTING THE LIMITS INDIVIDUALLY
If the limits need to be changed after the initial limit setting procedure, it is possible to change the limit
positions individually. One limit can be set without the other limit needing to be set. The motor can be in any
postion to initiate the procedure.
Stop the blind in the
desired intermediate
position
Press both the
UP
and
DOWN
buttons simultaneously until
the motor makes a brief jog in
both directions.
The intermediate position has
been set.
Press and hold the
STOP
button
for at least 3 seconds: the shade
will move to the intermediate
position.
Press both the
UP
and
DOWN
buttons simultaneously until
the motor makes a brief jog
in both directions.
10. SETTING THE INTERMEDIATE POSITION
11. RECALLING THE
INTERMEDIATE POSITION
12. ERASING THE
INTERMEDIATE POSITION
TO CHANGE THE
UP
LIMIT:
TO CHANGE THE
DOWN
LIMIT:
1
1
2
2
3
3
From any point between the existing limits, press
and hold both the
PROG-FC
button and the
UP
button until the motor makes a breif jog.
Note: during “limit setting mode” the operations
are in “deadman control” (The UP and DOWN
buttons must be held DOWN inorder to move the
motor.).
From any point between the existing limits, press
and hold both the
PROG-FC
button and the
DOWN
button until the motor makes a breif jog.
Note: during “limit setting mode” the operations
are in “deadman control” (The UP and DOWN
buttons must be held DOWN inorder to move the
motor.).
Press and hold the
UP
botton until the
desired new
UP
limit
is reached.
Press and hold the
DOWN
botton until the
desired new
DOWN
limit
is reached.
Press the
STOP
button to set
the limit. The motor makes
a brief jog to confirm. The
new up limit is set.
Press the
STOP
button to set
the limit. The motor makes
a brief jog to confirm. The
new up limit is set.
1
2
