www.AVOutlet.com
Manual Mode
: The transmitter works only by sending up stop and down commands to channels or groups
by manually pressing the button on the transmitter.
Automatic Mode
: The transmitter will operate with manual control as well as executing schedules auto-
matically.
Random Mode
: The transmitter will operate with manual control and all schedules will execute with a
delay from 0-30 minutes. For example, if the schedule is set to go off at 8:00, when in random mode, the
schedule will go off anywhere between 8:00 and 8:30.
PROGRAMMING TRANSMITTER (Fig.1)
CAUTION: If more motors with receiver have to be installed, it is important to power up
only one motor at time
during the first programming session, in order to avoid any interferences with the others.
1.
Power up the motor to be programmed.
2.
Hold SYNC pressed until the motor starts moving.
3.
Check the rotation of the motor, then release SYNC (the motor stops).
4.
Within 5 seconds press the corresponding button (i.e. UP if the motor rotates upwards or DOWN if vice
versa).
In this way the transmitter has been programmed and the rotation of the motor has been synchronized.
ADDING TRANSMITTER (Fig.1)
2.
Hold SYNC pressed of a transmitter
already paired
until the motor starts moving.
3.
Check the rotation of the motor, then release SYNC (the motor stops).
4.
Within 5 seconds press the corresponding button (i.e. UP if the motor rotates upwards or DOWN if vice
versa) on the
new transmitter being added
.
Additional transmitter is now added
CHECKING/CHANGING DIRECTION (Fig.2)
IMPORTANT: change direction must be performed before starting limit setting otherwise limits must be reset.
Press
UP or
DOWN button
the motor should go UP or DOWN, otherwise to change direction:
1.
Press and hold SYNC button till the motor starts moving
2.
Press
STOP
button: The motor makes a brief jog.
Direction of the motor has been reversed.
OFF
ON
FIG. 1
FIG. 2
