PROGRAMMING TRANSMITTER
CAUTION: If more motors with receiver have to be installed, it is important to power up
only one
motor at time
during the first programming session, in order to avoid any interferences with
others.
1
Power up the motor to be programmed.
OFF
ON
2
Press and hold the PROG-TX button
until the motor starts moving.
A
3
Check the rotation of the motor, then
release PROG-TX (the motor stops).
4
Within 5 seconds press the
corresponding button (i.e. UP if the
motor rotates upwards or DOWN if
vice versa). The transmitter has been
programmed and the rotation of the
motor has been synchronized.
PROGRAMMING
