GAOKIN E02, Maintenance Manual

Page: 15 / 30

第
- 15 -
页
high speed。
5.1.2 Engine starting
Prohibit
The engine can be only started with electricity. It is not allowed to press the
electric start button for a long time.
Start engine in N-shift. If it is not in N-shift, ensure the clutch is off before starting
engine.
Starting time should be no more than 5s each time, continuous starting should not
over 5 times and interval should be no less than 10s.Engine starting failed in 5 continuous
times, it would be regarded as engine starting fault.
1）Engine with carburetor,
Starting when engine at cold state, close choke valve and
open the throttle properly, after the engine started, reopen the choke valve.
2）Engine with EFI system，it takes about 10s to do self-checking before starting
Warn It is not allowed to start engine before EMS self-checking finished
After engine started, preheating for 1-2 minutes at idling speed, avoiding to work in high
RPM with high load.
Note
The electric control system of the engine must work with engine against reverse
ignition function. Or it might cause starting system damaged( such as starting gear
、
shaft
、
one-way clutch, motor etc.)
5.1.3 Idling working and adjustment
I
dling speed has been adjusted when left factor. If adjust idling speed again, ensure the
engine is hot and locate at N shift, spin carburetor idling adjustment screw, make the idling
stabilized at 1500
±
150r/min. If adjusting the screw can’t reach the requirement, you can
adjust carburetor mixed ratio.
Engine with EFI, adjusting throttle valve idling screw is not suggested. It should
be performed with the guidance of expert.
5.1.4 Accelerating working
Avoiding to increasing accelerator rapidly when engine accelerates, it is
suggested to increase stable. Engine RPM、shift and speed should match well during
driving.
warn A. Engine Working at high shift low RPM should be avoided
B. Engine Working at low shift high RPM for a long time should be avoided
5.1.5 Clutch operation