01A.00
7
4. INSTALLATION
1)
Secure three screws inside a PCB
board shield’s three unit holders with
metal rings attached in the end.
2)
Connect all necessary cables to a PCB
board before attaching the shield to an
installation surface.
3)
Under the PCB board shield has a 32-
pin connector which matches the main
camera body’s 32-pin socket; The
shield’s three unit holders also align
with the main camera body’s three unit
holder holes.
4)
Once cable connect is complete
along with brackets and poles on an
installation spot, hook the roll-up
string that is attached to a board
shield to the main body. Main body
has a secured string holder hole.
5)
Align the connector and socket, and
then push the main body to conjoin.
6)
Once two units are attached, rotate
the main camera body counterclockwise
to secure the lock.
Caution
!
To prevent products from damaging, place the camera on stable and non-vibrat
ing surfaces. If the stability is in doubt, consult with safety personnel for reinfor
cements, and then proceed with the installation.
Roll-up
String hole
32-pin socket
ZN-PTZ202XE Installation Guide