29
ENG-
The connection between two IP addresses can be checked using the command ping. You can
thus check whether the device in the network is active.
¾
Open the DOS input window and enter the command ping followed by the IP address of
the device.
¾
When the device is found, you receive in response: Reply from ..., followed by the
number of bytes transmitted and the transmission time in ms. Otherwise the device
cannot be addressed via the network. This can have the following causes:
The device is not correctly connected to the network. In this case, check the connecting
leads. The device is not correctly integrated into the network. Check the IP address, the
subnet mask and the gateway IP.
Reset
In order to activate the new configuration the system must be rebooted by entering
the current IP address followed by a
reset
operation:
ex.
http://192.168.0.1/reset
SERVICE
