15
ENG-
Display Settings
Ù
Display stamping
You can configure the device so that the camera name, time and alarm source are displayed
in the video image. Select
Top
if the names are to be displayed at the top of the image, or
Bottom
if the names are to be displayed at the bottom of the image. If you do not wish the
names to be displayed, select
Off
.
Camera name stamping:
camera name is displayed in the left-hand corner of the video
image.
Time stamping:
date and time are displayed in the right-hand corner of the video
image.
Alarm mode stamping:
select
On
to permanently display the alarm source (e.g. video
signal) in the video image for information.
Select
Off
to never display the alarm source or
On alarm
if the
alarm source is only to be displayed in the event of an alarm. Or
select
On alarm/hold
if the alarm source is to continue to be
displayed even after the end of the alarm status or until it is
confirmed.
Video settings
Ù
Video quality setup
You can set up the video picture to meet your own particular requirements. To enable you to
control the current video picture it is shown in a small window beside the sliders. The changes
are effective immediately.
Picture contrast:
you can adjust the contrast of the video picture to suit the working
environment.
Picture saturation:
you can use this function to set the colour saturation and achieve
the most realistic colour reproduction on the monitor.
Picture brightness:
you can use this function to adjust the brightness of the video
picture to suit the working environment.
