VANDAL RESISTANT DOME CAMERA
ZC-D4000 series
Enclosure Installation Manual
Precautions
・
Do not attempt to dismantle the camera module mounted
within the dome. There are no user serviceable parts within
the camera module. Refer servicing to qualified personnel.
・
Handle the camera with care. Do not abuse the camera.
Avoid striking or shaking it. Improper handling and storage
could damage the camera.
・
Do not operate the camera outside of its temperature,
humidity or power source rating range. Please refer to the
environmental information provided overleaf.
Methods for mounting the enclosure
There are three main ways to mount and attach the dome
enclosure:
A: Flush mount using screws
B: Flush mount using locking arms
C: Surface mount using the outer ring
Note: Always use the template provided
When mounting externally
When mounting externally using the four base holes, use
the supplied rubber o-rings (shown in C) within the
mounting holes to ensure a moisture-resistant seal. Make
sure that the cable entry through either knockout panels is
suitably sealed against moisture ingress. Regardless of
whether the locking arms are used for installation or folded
away (in favor of another installation method), always
make sure the locking arm screws are tight enough to
compress the rubber o-rings to maintain the moisture seal.
Packing list
Vandal Resistant Dome Enclosure
4 #12 x 1 1/2 mounting screws
4 rubber sealing o-rings
4 wall plugs
1 Torx bit
1 Camera chassis & liner
1 wire ended power adaptor lead
4 plastic screw caps to conceal the dome cover screws
1 large rubber gasket (fitted between enclosure and
outer ring)
1 ¾” sealing plug (1/2” sealing plug fitted to enclosure)
1 ½” and 1 ¾” cable entry grommets
Weather resistance
IP66 Rated
