Firmware Update Procedure
1. Save the firmware file to your computer.
2. Go to Setup > System > Maintenance within the camera web browser setup.
3. In the Firmware Update section, browse to the desired firmware file on your computer. Click OK.
NOTE:
Do not disconnect power to the unit during the upgrade. The unit will restart automatically
after the upgrade has completed. (1~5 minutes)
4. If you suspect the firmware upgrade for the camera has failed, always wait at least 5-10 minutes
before restarting the upgrade process.
5. CBC reserves the right to charge for any camera repair which can be attributed to faulty upgrading
by the user. Always read the upgrade instructions and firmware release notes before updating the
firmware.
System Reset (Factory Default Reset)
There are two ways to reset the camera back to factory default.
Using the web browser:
1. Go to SETUP > System > Maintenance.
2. Click Factory Default Button and wait 1 minute for camera to reboot.
Using the Reset Button on rear panel of the camera:
1. Disconnect the power adapter (or the network cable, if PoE is being used).
2. Press and hold the Reset button while reconnecting power.
3. Keep the Reset button pressed until the Status Indicator color changes to RED and starts
blinking (which may take up to 15 seconds).
4. Release the Reset button.
5. When the Status Indicator changes to Green (which may take up to 1 minute), the process is
complete and the camera has been reset.
NOTE:
The unit will now have the default IP address from a DHCP server.
Use the ‘PixelPro Discovery Tool’ to discover and connect to the camera.
