Ganz PIXELPRO SERIES, Interface Manual

Page: 34 / 111

Printed Documentation
26
Objects that are present inside a zone or pass through a line will trigger the rule and raise an
alarm.
Object Direction
Enable the object direction rule on the selected zone by checking the Direction Filter box in
the properties inspector. Adjust the direction and acceptance angle to suit the detection
scenario.
Objects that travel in the configured direction (within the limits of the acceptance angle)
through a zone or over a line trigger the rule and raise an alarm.
Object Enter and Exit
Enable the object enter and exit detection by checking the corresponding check boxes in the
properties inspector and click apply.
An object entered alarm is raised when an object crosses from the outside to the inside of a
detection zone. Conversely, an object exited alarm is raised when an object crosses from the
inside to the outside of a detection zone: