Fixed Camera Quick Start Guide
November 2014
7
www.ganzsecurity.com
Fixed Mount 320x240 & 640x480 Pin-Out
Pins 1-3: Power (GND, 24V AC, 12-24 DC/24V AC)
Pins 3-4: RS-485 (POS, NEG)
d.
AC/DC Power for Fixed Mount: Connect wires to power
block according the pin-out shown below:
i.
If powering the camera with an AC supply, connect
AC+ to the 24VAC input and the AC- to the other
24VAC input
ii.
If powering the camera with a DC supply, connect the
DC+ to the 12VDC input and the DC- (or ground) to
the GND input.
Fixed Mount Pin-Out
e.
RS-485: Connect wires to power block according to the
pin-out sown on the left (Fixed Mount 320x240 &
640x480 only)
12.
Reconnect Power to the existing cable(s)
13.
Check for Solid LED on the Ethernet connector to acknowledge
connectivity to the IP network. The status LED indicators are:
a.
LED 1: Solid Green for 10MB connection or Flashing
Green for Activity
b.
LED 2: Solid Amber for 100MB connection.
14.
Place the supplied white desiccant into the Back Cover
15.
Assemble the Back Cover. If captive screws are provided in the
Back Cover, secure to the IP camera with a Phillips #2
screwdriver. Otherwise, secure Back Cover to the IP Camera using
two #6 screws and two Master Seal Washers (metal side against
the head of the screw and gasket side against the camera body).
Tighten the 2 fasteners to approximately 10 in-lbs. of torque
16.
Assemble the 2 Rubber Stem Bumpers onto the 2 detents in the
concave surface of the Solar Shroud
17.
Snap the Solar Shroud, to the Base Mount
