GL7p - Battery-powered, door-mounted electronic locker lock GL7p
Operation
www.gantner.com
HB_GL7p--EN_12
51
6
OPERATION
RF exposure statement
The users must keep at least 20 cm separation distance from the device, except during the identification and
operation process at the device (e.g. PIN-code input), which must be performed as described in this manual.
6.1 Target Group
This chapter contains information for the technicians who commission the GL7p and who check it in case of operation
problems.
6.2 General
To operate the GL7p (e.g., to lock or unlock a locker), the user must identify themselves at the GL7p with their RFID
data carrier or PIN code.
For identification via RFID data carrier, the button must be pressed in with the data carrier. Pressing the button
activates the GL7p and the data carrier is read.
For identification via PIN code, the PIN code must be entered in order to lock or unlock the locker. After entering the
PIN code, it is confirmed with the "
✓
" key or by pressing the push button. An RFID data carrier is then not
necessary. The length of the PIN code is configurable. So that the personal PIN codes remain protected, the PIN
codes entered are not recorded in the lock bookings and cannot be read.
To save battery power, the GL7p is deactivated in its normal state. For this reason, the electronics must be
activated before identification or operation can occur using a data carrier, which is done by pressing the
button completely in or by pressing one of the keypad buttons.
An LED display and audible buzzer indicate the operational states and provide feedback on user interaction.
6.3 Operating Modes
The GL7p can operate in "free locker" mode or "personal locker" mode. In free locker mode, the user can choose any
unoccupied locker they want to use. In personal locker mode, the user is assigned a specific locker and only they
have access to use the locker.
When free lockers and personal lockers are used together in one system, it is recommended that the locker numbers
are unique for both functions. This means that the same locker number should not be used for both a personal locker
and a free locker.
The following operating modes are possible:
“Free Locker” Operating Mode
- Free locker selection with or without duration of use function (default)
NOTE!
The duration of use function for free locker mode is only available for MIFARE systems.
- Free locker universal
- Free locker unique number
