Copyright © Ganterud Lifting Solutions AB | www.ganterud.se | [email protected]
18
5 Tandem operation
Tandem operation of two GANTERUD L3 lifting yokes at the same time with one remote control.
Start by deleting both the remote controls as described below:
Make sure that the lifting yoke(s) are turned off with the power switch, and that the remote control(s)
are turned off.
1. Turn on “remote control 1”.
2. Turn on the power switch on “lifting yoke 1”.
3. Press
button “1” and button “A”
on the remote control at the same time for approx. 5 seconds.
“Remote control 1” has now been deleted.
4. Press the various buttons to check that it is not working. Note: take care and monitor both lifting
yokes to make sure that no risk of injury can arise.
5. Repeat this procedure with the other lifting yoke.
6. Then turn off the power switch for “lifting yoke 1” and “remote control 1”.
1. Turn on “remote control 2”.
2. Turn on the power switch on “lifting yoke 2”.
3. Press
button “1” and button “A”
on the remote control at the same time for approx. 5 seconds.
“Remote control 2” has now been deleted.
4. Press the various buttons to check that it is not working. Note: take care and monitor both lifting
yokes to make sure that no risk of injury can arise.
5. Repeat this procedure with the other lifting yoke.
6. Then turn off the power switch for “lifting yoke 2” and “remote control 2”.
Then decide which lifting yokes are “lifting yoke 1” and “lifting yoke 2” respectively, and turn off
both lifting yokes with the power switch. Also turn off both remote controls.
1. Turn on “remote control 1”.
2. Turn on the power switch on “lifting yoke 1”.
3. Press both arrow keys (
button “1” and button “2”
) on “remote control 1” for approx. 5 seconds.
4. “Remote control 1” is now synchronised with “lifting yoke 1”.
5. Then turn off the power switch for “lifting yoke 1” and “remote control 1”.
1. Turn on “remote control 1”.
2. Turn on the power switch on “lifting yoke 2”.
3. Press both arrow keys (
button “1” and button “2”
) on “remote control 1” for approx. 5 seconds.
4. “Remote control 1” is now synchronised with “lifting yoke 2”.
5. Then turn off the power switch for “lifting yoke 2” and “remote control 1”.
1. Turn on the power switch on “lifting yoke 1” and “lifting yoke 2”.
2. Turn on “Remote control 1”.
Test all the functions. Note: take care and monitor both lifting yokes to make sure that no risk of injury
can arise.
