WPX
INSTALLATION MANUAL PAGE 3
STRONG. SIMPLE. COMPACT.
WPX series wet location fixtures are typically surface mounted (Ceilings, Walls, etc). If mounting on the ceiling,
it is recommended to keep the fixtures 2-3 feet in from the wall.
Mark the clip locations. If possible, use a chalk line and snap a line down the entire length of the run, where the
fixtures are intended to be mounted. Next, mark on the line where the mounting clips are to be affixed, using
the diagram below for reference. Each WPX8 and WPX6 fixture uses three mounting clips - one near each end,
and one in the middle. Each WPX4 and WPX2 uses two mounting clips, one near each end.
After marking the clip locations, secure the mounting clips to the wall or ceiling using proper mounting hardware.
Snap the fixtures into position by pressing them up into the mounting clips. Ensure that the white connector is
facing toward the cable input (leader cable or jumper) on all fixtures.
The (80W, 120W, 240W, 320W, 480W and 600W) power supplies are rated for wet location use and are designed
to be installed without the use of an additional enclosure or wiring box. Placing the supplies in an additional
enclosure may prevent proper cooling and cause them to overheat.
3. Mount Fixtures
4. Mount Power Supplies
Figure 3.2:
Mounting Clip Placement for 4FT Jumper
Figure 3.1:
Mounting Clip Placement for 1FT Jumper
www.ggled.net
T
800.285.6780
E
Rev Date 19 0312
