G&D ControlCenter-IP 2.0, Installation Manual

Page: 44 / 60

Initial configuration of the network settings
12 · G&D ControlCenter-IP 2.0
Initial configuration of the
network settings
A basic requirement to access the web application is to configure the network set-
tings of the IP matrix switch on which the web application is operated.
How to configure the network settings before integrating the device into the local
network:
1. Use a category 5 (or better) twisted pair cable to connect the network interface of
any computer to the device’s Network A interface.
2. Ensure that the IP address of the computer’s network interface is part of the sub-
net to which the device’s IP address belongs to.
3. Switch on the device.
4. Start the computer’s web browser and enter the URL https://192.168.0.1 in the
address bar.
5. Enter the following data in the login mask:
6. Click on Login .
NOTE:
In the defaults, the following settings are pre-selected:
 IP address of network interface A : 192.168.0.1
 IP address of network interface B : address obtained using DHCP
 global network settings: settings obtained using DHCP
NOTE:
Use the IP address 192.168.0.100 , for example.
Username: Enter a username.
Password:
Enter a password for your user account.
IMPORTANT: Change the administrator account's default password.
To do this, log into the web application with the administrator account and
then change the password.
The default access data to the administrator account are:

Username: Admin

Password: see login information on the label on the bottom of the device
NOTE:
The default admin password for devices manufactured before
June 2020 is 4658 .