5
Remove and Discard Plastic Washers
ASSEMBLY INSTRUCTIONS
Support Post Installation
To install the support posts you must fi rst
remove the mounting bolt from the mounting
plate that sets inside the central cavity of the
turntable. There are large holes stamped on
the underside of the turntable that allow you to
support the mounting plate with your fi ngers
while removing the mounting bolt.
After removing
the mounting bolt, remove
and discard the plastic washers that are
installed for shipping purposes.
Turntable Installation
To install the turntable, position it over the
turntable pin and align the bolts (included in
separate bag) with the holes in the fl ange.
Secure them with the included 6mm allen
wrench.
Note:
When purchased with the optional fl oor
stand, it is most convenient to attach the base
to the fl oor stand at this point. See instruc-
tions provided with the optional fl oor stand.
Winder Bar Installation
To install the winder bar, slide over the post
on the base and secure it with the 2 allen
set screws.
Note:
When purchased with the optional fl oor
stand, it is most convenient to attach the base
to the fl oor stand at this point. See instruc-
tions provided with the optional fl oor stand.
