SUPPORTS - pag. SU 5
Holding bar
ATTENTION:
For a correct and safe usage of the holding bar with MINI it is necessary to read
carefully the text contained in sections “INFORMATION” (from pag. IN 1) and
“BODY” (from pag. BO 1) of the usage instructions.
The holding bar must be placed onto the holding frame (see lay-out on pag. SU 1).
It is forbidden to use accessories that are different from those supplied by
GAMMA.
Failure to observe the prescriptions and the procedures described in this
document absolves the manufacturer of any responsibility for damages to things
or people.
Function
The holding bar can support 25mm or 30mm standard clamps.
Features
The bar is made of stainless
steel and is available in the
following dimensions: 25 x
10 mm (cod. .0690); 30 x 10
(cod. .0691).
Assembly
1
Insert the holding bar
between the two bars of the
holding frame.
2
Insert the clamp (a) and
fix it with a cross
screwdriver.
3
Carry out the same
operation on the other end of
the bar.
Usage
Hang accessories onto it.
Make sure not to exceed the maximum allowable loading weight indicated on the
adesive label (b) )
stuck on the upper part of the pole.
Removal
Follow the procedure described for assembly in reverse order.
Maintenance
Refer to what is reported on pag. IN 12.
Decommissioning and disposal
Refer to what is reported on pag. IN 14.
a
b
