- 3 -
5. Use Guide
5.1 Do not use under the environment of heavy dusty and high vibration.
5.2 Place the article in the center of the platter as far as possible.
5.3 Never use high corrosive solvents to clean it.
5.4 Do not weigh overload, weight (tare included) can't exceed its Max. Capacity
plus 9d ("d" is division value). If the weight exceeds this value, the indicator will
display as "FULL", and may possibly give out beep sound.
5.5 Do not place article on platter for a long period of time and never bump platter
in a sudden, otherwise, the load cell may be damaged.
5.6 Be sure that the ground terminal of AC power is properly grounded.
5.7 Don't disassemble it without authorization.
5.8 If the display doesn't change during operation, turn off the switch of battery
and pull out the adaptor plug, then turn on the scale again.
5.9 If something is wrong, immediately turn off the switch of battery (or storage
battery) and pull out the adaptor plug. Non-professional staff can't fix it without
authorization.
Contact our sales agent in local area.
5.10 To recalibrate the scale, do it after warmed up for 30minutes.
6. Operation
6.1 Power-on
6. 1.1 Connect power adaptor and switch on the scale with AC power. The scale
will give out beep sound and display a version number. At the same time, the
backlight is light on for about 1 second, then displays the max capacity, finally to
execute self-checking from 9 to 0. If zero position is normal, the display will show
"0.00".
6.1.2 Set the switch at 'I' side directly to power on scale with DC power.
6.1.3 When the display is LCD, after the adaptor is inserted, DC power will also be
cut off even if the switch is set at "I" While the display is LED, press the switch at
"I" side, DC power is on, otherwise, DC power is off.
6.1.4 If the "Lo-bat" appears, change the battery or to charge the storage battery in
time. Otherwise, it will shut off power automatically.
6.1.5 When the display is LED, in order to prolong the battery working time, the
scale has been set a saving mode, i.e. within 10 seconds, if the scale remains at
zero and no keypad is pressed, the scale will display only "0".
6.2 Zero setting
When the weight is within ± 2%F • S, press [ZERO] to make the indicator displays
"0". The repeated zero range is ± 5%F • S.
Note: Under tare state, zero setting does not work.
