Instruction Manual
- 26 -
The adjustment reed may slightly touch the ref-
erence point indicator but must not push it
downwards.
Remove the reference plane adjustment reed
and the reference point indicator. Now you can
insert the upper cast into the corresponding im-
prints in the bite fork. After closing the transfer
stand, you can analyze the distance between
the upper section and the model. Choose the
best-fitting block. Make sure that the layer of
plaster is as thin as possible. This will minimize
the distortion effects of plaster expansion.
Open the transfer stand and fit in the distance
block, with a mounting plate already attached.
Moisten the model, and make sure to apply an
adequate amount of plaster on the mounting
plate and the model. Close the transfer stand,
and allow the plaster to harden, according the
manufacturer's instructions.
Now you can remove the model from the trans-
fer stand and insert it into the Reference SL ar-
ticulator, for mounting the lower jaw model.
Summary of Contents for Condylograph comfort Set
Page 10: ...Instruction Manual 10 The procedure on the patient is completed...
Page 60: ......
