46
[51]
Electrical supply
•
This product uses a separate power cable. In case this power cable is damaged, it
should be replaced by an original equipment manufacturer supplied cable.
•
The power socket must be easily accessible after installation.
•
Check the correct voltage on the basis of nameplate.
•
Check the cable cannot be clamped or get stuck.
•
Use of an extension cord is not recommended.
•
If necessary, allows a cable renewal by a licensed electrician.
Due to under-or peak voltage may cause damage, so that the cabinet is turned
off. Gamko is not responsible for any consequential damages.
.
[52]
Chapter 3 Usage
Commissioning
•
Clean the appliance before commissioning. For further details see maintenance.
•
After the installation, wait at least 2 hours before starting the appliance.
•
Plug into a grounded outlet.
Thermostat
Using the thermostat
For use and settings of the thermostat, please refer to the manual supplied with this
product.
Application with XR07CX type thermostat:
To see the set point.
1. Push the SET key two times, the set point will be showed.
2. Push the SET key three times to return to normal visualisation.
To change the set point
1. Push the
SET
key for more than 2 sec and then push the SET key again;
2. The value of the set point will be displayed and the “°C” LED starts blinking;
3. To change the Set value push the
UP
or
DOWN
button;
4. To memorise the new set point value push the
SET
key three times.
Note
: The new set value is fixed even if you leave the settings without the SET button
have been pressed.
Light on/off
Up/down button
settings
Manual defrost
Set button
Summary of Contents for 000030058
Page 2: ...2 Gebruiksaanwijzing 4 Mode l emploi 20 User Manual 37 Gebrauchsanweisung 55...
Page 19: ...19...
Page 54: ...54...
